Ideal
80 mm (3”) Borewell submersible pumpsets are built with impellers &
diffusers made of thermo plastics and other vital components like check
valve housing and suction inter connector are made of graded cast iron,
outer shell made of high quality stainless steel. The optimal design of
impellers and diffusers offers best possible hydraulic efficiency.
These pumps are powered by a water filled, rewindable submersible motor
suitable for continuous duty. The stator is wound with special water
proof synthetic film insulated copper winding wires and made up of low
watt loss steel laminations assembled under pressure and rigidity
locked in stainless steel stator shell. Specially designed high
performance thrust bearings (SS with Carbon) are used to withstand
axial and down thrust loads with minimum wear and tear. Dynamically
balanced rotor gives vibration free and noise free operation, thereby
increases efficiency and life cycle of the motor. These motors must be
filled with clear, cold, fresh water before erection.
| Power Range |
0.37 kW – 1.1 kW (0.5HP-1.5 HP) |
| Speed |
2880 RPM |
| Version |
Single phase 200-240V,50 Hz, A.C. Supply |
| Maximum total head |
93 metre ( 9.3 bar ) |
| Maximum flow rate |
5400 LPH (5.4 M3 / Hr) |
| Maximum Outter diameter in mm |
73, 75& 77 |
| Nominal outlet size in inches |
1 & 1 ¼ |
| Degree of Protection |
IP 58 |
| Direction of Rotation |
Clockwise viewed from driving end |
| Thrust Load |
1500 Ibs |
| Minimum cooling flow along the motor |
0.15 m/sec |
| Type of Duty |
S1 (continuous) |
| Method of starting |
Capacitor Sart and Capacitor Run (CSCR) |
| Maximum starts per hour |
12 times |
| Mounting Standard |
As per NEMA |
- Fitted with imported motor protector
- Silver brazed rotor
- Designed for wide voltage fluctuations
- Water –cooled rewindable motor
- Low maintenance cost
| Material of Construction of Pump |
| Part Name |
Material |
| Check Valve housing |
CI |
| Check Valve Seat |
Nitrile Butyle Rubber |
| Diffuser Chamber |
SS 304 (Shell) |
| Impeller |
Modified PPO (Noryl) |
| Diffuser |
Modified PPO (Noryl) |
| Suction Inter Connector |
CI |
| Inlet Screen |
SS 304 |
| Pump Shaft |
SS 410 |
| Cable Guard |
SS 304 |
| Coupling |
SS 410 |
| Material of Construction of Motor |
| Part Name |
Material |
| Upper and Lower Housing |
Cast Iron and Mild Steel |
| Stator Shell |
Stainless Steel 304 |
| Shaft |
Stainless Steel 410 |
| Journal Bushes |
Leaded Bronze |
| Thrust Assembly |
Stainless Steel 420 and Graphite Carbon |
